Water Heater Installation & Replacement
Retire a worn tank and pick a size, fuel type and spot that suit the house.
Smell gas? Leave the house and phone the gas utility from outside. To install or repair a gas line to a range, dryer, grill or water heater, call and speak with a dispatcher.
Do not flip switches, light flames or use your phone inside if you smell gas. Leave first and call from outside.

Utilities add a rotten egg odor to natural gas. If you notice it, leave the building without touching switches and phone the gas utility from a safe distance. Dial 911 if the smell is strong.
Stay out until the utility confirms it is safe.
A new line serves a range, dryer, outdoor grill or fire feature, or a water heater. The plumber sizes the pipe for the load, routes it, installs a shutoff and tests it.
Outdoor lines need proper protection and burial depth, and some need a permit.
Old flex connectors, corroded fittings and damaged pipe are common sources of leaks. A failed joint is repaired or the section replaced.
Plumbers test with pressure gauges or a leak detector, not by guesswork.
Most gas work requires a permit and an inspection. The contractor normally arranges both, though the quote should say so.
Wait for confirmation that the line passed inspection before running the appliance.
Gas line cost follows length, material and difficulty.
Ask for the pipe material, the permit and the pressure test in the quote.
Any smell of gas is a reason to act at once.
Locate the gas meter shutoff and the appliance shutoff. Keep clear of the work area.
Write down what you want connected, with the make and model if known.
The plumber checks the meter, the pipe route, the existing fittings and the appliance. They size the line for the load and test pressure after work.
You get a clear scope and an inspection plan.
A single failed joint or connector is a simple repair. Corroded or undersized pipe is better replaced.
See water heater installation for gas water heater work.
Many Arizona homes add outdoor kitchens, grills and fire features, and each needs a properly sized gas line. Burying lines at the required depth and protecting them from sprinklers and tree roots matters.
Garage water heaters and heaters need gas shutoffs and sediment traps within reach.
Retire a worn tank and pick a size, fuel type and spot that suit the house.
Descale an on-demand heater, diagnose an error code or install a new unit.
Underground, rough-in and trim plumbing for new builds, additions and remodels.
Get out of the house without touching switches or flames, then ring the gas utility from outside. Dial 911 if the odor is strong.
In most cases, yes, and the contractor usually pulls it.
Yes. The plumber sizes the line, buries it properly and installs a shutoff.
By a pressure test, and often by a leak detector at fittings.
Cost depends on run length, surface and appliance load. Ask for a written quote.
If you smell gas, leave and call the utility first. Then call the 24/7 line about the repair.
Tell the dispatcher what you plan to connect so the right plumber is sent.
The utility handles the meter. The plumber handles the lines on your side.
Smell gas? Get out first. If not, phone and name the appliance you want connected.
Service area centered on Avondale and nearby Maricopa County cities.